Cafe CSB42WSKSS Spezifikationen PDF herunterladen (Seite 2)

CSB42WSK

GE Café

™

Series 42" Built-In Side-By-Side Refrigerator

Total volume and shelf

area are calculated by

the Association of Home

Appliance Manufacturers’

standards.

Listed by

Underwriters

Laboratories

Specification Revised 10/15

For answers to your Monogram, GE Profile

™

Series

or GE

Series appliance questions, visit our website

at geappliances.com or call GE Answer Center

service, 800.626.2000.

24"

*84"

*3" TO 4"

1-1/2"

FLOORING

For proper installation, this refrigerator must be

placed on a level surface of hard material that

is at the same height as the rest of the flooring.

This surface should be strong enough to support

a fully loaded refrigerator, or approximately 1500 lbs.

NOTE: Protect the finish of the flooring. Cut a

large section of the cardboard carton and place

under the refrigerator where you are working.

WATER AND ELECTRICAL LOCATIONS

The opening must be prepared with the

electrical and water supply located as shown.

GROUNDING THE REFRIGERATOR

IMPORTANT—PLEASE READ CAREFULLY

FOR PERSONAL SAFETY, THIS APPLIANCE

MUST BE PROPERLY GROUNDED.

The power supply cord of this appliance is

equipped with a three-prong (grounding) plug

which mates with a standard three-prong

(grounding) wall receptacle to minimize the

possibility of electric shock hazard from this

appliance.

Have the wall outlet and circuit checked by a

qualified electrician to make sure the outlet is

properly grounded.

Where a standard 2-prong wall outlet is

encountered, it is your personal responsibility

and obligation to have it replaced with a properly

grounded 3-prong wall outlet.

DO NOT, UNDER ANY

CIRCUMSTANCES, CUT

OR REMOVE THE THIRD

(GROUND) PRONG FROM

THE POWER CORD.

DO NOT USE AN ADAPTER PLUG

TO CONNECT THE REFRIGERATOR

TO A 2-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD

WITH THIS APPLIANCE.

*Finished Width

Electrical

Area

84 1/2" max

83 1/2" min

Finished

Opening

74"

From Floor

to Bottom

of Electrical

24"

5" 5"

3 1/2"

Water

Supply

3 1/2"

THE CUTOUT DEPTH MUST BE 24"

The refrigerator will project forward, slightly beyond

adjacent cabinets, depending on your installation.

ADDITIONAL SPECIFICATIONS

A 120 volt, 60Hz, 15 or 20 amp power supply is

required. An individual properly grounded branch

circuit or circuit breaker is recommended. Install

a properly grounded 3-prong electrical receptacle

recessed into the back wall. Electrical must be located

on rear wall as shown.

NOTE: GFI (ground fault interrupter) is not recommended.

Water line can enter the opening through the floor or

rear wall. The water line installed should be 1/4" O.D.

copper tubing or GE SmartConnect

™

tubing between

the cold water line and water connection location. The

line should be long enough to extend to the front of the

refrigerator. Installation of an easily accessible shutoff

valve in the water line is required.

THE INSTALLATION SPACE

DIMENSIONS AND INSTALLATION INFORMATION

SIDE PANELS

Side panels (not supplied)

must be used whenever

the sides of the refrigerator

will be exposed. The 1/4"

side panels will slip into

the side case trim. Order

side panels from your

cabinet manufacturer.

* Depending on installation height.

* The finished

cutout width must

be: 41-1/2" for

42" models

1 2 3

CSB42WSK 1

Kommentare zu diesen Handbüchern

Keine Kommentare

Cafe CSB42WSKSS Spezifikationen Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Cafe CSB42WSKSS